1. Locate existing filter and remove it by turning it counter-clockwise as shown in the graphics
2. Holding the new filter in your hands, carefully remove the packaging and sanitary end-cap from the new filter
3. Insert the new filter into the refrigerator filter receptacle. Rotate the filter clockwise until the arrow on the bottom is aligned with the arrow on the refrigerator filter head. Ensure that the filter is fully installed in the refrigerator head using a full 1/4 turn. This is required to activate the internal valve inside the refrigerator. If the filter is not turned a full 1/4 turn the valve will not fully open and may cause the water flow to be slow, or even cause the valve to make a chattering noise during use
4. Dispense water into a glass looking for good water flow. If flow is slow, remove and reinstall filter ensuring that the filter is turned a full 1/4 turn
NOTE: Initial flow rate may be slower than expected. Full flow rate should be restored within 24-36 hours.
5. Check the filter a final time for leaks
6. Reset the filter replacement indicator light by holding down the Alarm (or Energy Saver ) button for 3 seconds, or refer to your refrigerator’s owner’s manual
Images are for illustration purposes only.
Model Location may vary depending on refrigerator model.
Do not use with water that is microbiologically unsafe, or of unknown quality, without adequate disinfection. Protect from freezing.
FILTER REPLACEMENT SHOULD GENERALLY BE PERFORMED EVERY 6 MONTHS.
FILTER REPLACEMENT MAY NEED TO BE CONDUCTED MORE OFTEN IN AREAS
WHERE THE WATER QUALITY IS MICROBIOLOGICALLY INFERIOR.
The risk associated with small parts can cause choking if swallowed.
Keep children away from small parts during the replacement of the water filter.